Painting Clamp 30 cm is an MP accessory for the MultiSprayStand. It helps hold loose parts in a fixed position while sanding, coating, flashing off or drying. The clamp is useful when a part should stay raised instead of lying flat on a bench, where edges can be blocked and wet coating can be marked by contact points.
The 30 cm format gives practical reach for many small and medium sized parts. Trim pieces, brackets, covers and loose components can be positioned so the working area remains accessible. That makes it easier to coat around edges, returns and difficult shapes without constantly touching or repositioning the part by hand.
A stable support setup improves handling and keeps the working process calmer. The clamp works as part of the MP stand system, alongside other holders and accessories for preparing and coating separate parts. It is a simple item, but it can make a noticeable difference when small parts need to be handled neatly from preparation to drying.
Use the clamp only with compatible stand equipment and secure the part before starting surface preparation or spraying. Check balance and clearance before coating, especially on heavier or irregular shapes. Keep the clamping point away from the visible finish area wherever possible.
Mount the clamp on the compatible stand system, position the part securely and check that the coated area remains accessible. After coating, leave the part supported until it can be handled safely without touching the finish.
| Item type | Stand accessory |
|---|---|
| Length | 30 cm |
| Compatibility | MP MultiSprayStand |
| Main use | Securing parts during preparation, coating and drying |
| Article number | 551141403 |
|---|
© 2026 All Rights Reserved.
Start with the job, the surface or the step you are working on.
