MP replacement needles restore the working tips of the MP lint needle set. Lint needles are used for very precise correction of tiny contamination points in fresh paint, especially small fibres, specks and local inclusions that need to be lifted carefully before the coating is finished. A sharp, clean needle makes that delicate task easier and helps reduce the need for larger sanding or polishing work later.
The 10-piece spare needle set keeps the lint needle tool ready for repeated use. Fresh needles are important because a damaged or contaminated tip can drag across the paint surface instead of lifting the defect cleanly. Replacing worn needles also helps maintain the fine control needed when working on fresh or recently applied coating material.
MP replacement needles are a small consumable, but they support a very specific finishing step. When a tiny fibre or dust point is caught at the right moment, careful removal can prevent a small defect from becoming a larger correction job. Use the needles only with the intended lint needle set and handle them with care. Clean technique, good lighting and steady control matter more than force during this kind of fine paint correction.
Needle replacement also matters for consistency between jobs. A fresh needle gives a clean contact point for delicate defect removal, while a bent or dulled tip can mark the coating. Keeping spare needles available makes the lint needle set more dependable during final inspection and correction.
Fit a clean replacement needle into the MP lint needle set and use the tool carefully to lift tiny fibres or dust defects from fresh paint. Avoid dragging the needle across the surface and replace the tip when it becomes worn or contaminated.
| Product type | Replacement needles |
|---|---|
| Quantity | 10 pieces |
| For use with | MP lint needle set |
| Use | Removal of tiny lint, fibre and dust defects from fresh paint |
| Article number | 581017134 |
|---|---|
| EAN / GTIN | 4016176267051 |
© 2026 All Rights Reserved.
Start with the job, the surface or the step you are working on.
