MP SprayGun Selena is a gravity feed spray gun supplied with a 1.5 mm nozzle and a 0.5 litre plastic flow cup. The setup is suited to primer, filler and general coating application where a practical spray gun is needed for controlled material delivery and a stable spray pattern.
The 1.5 mm nozzle gives a useful balance for many medium viscosity coating materials. It can support primer work, filling primers, surfacers and other compatible materials when the material is reduced and adjusted correctly. The 0.5 litre cup keeps the gun manageable while still holding enough material for many small and medium jobs.
A dedicated spray gun helps deliver a more even film than improvised application methods. Good atomisation, correct air pressure and steady hand movement are essential for a clean coating result. The gun should be matched to the coating material, viscosity, air supply and surface size before spraying begins.
Clean the gun before first use and after every spraying session. Set the air pressure and material flow for the coating material, test the spray pattern and apply even overlapping passes. Dismantle and clean the nozzle, needle and cup carefully so dried material does not affect later spraying.
Adjust the coating to the correct spray viscosity, set air pressure and test the spray pattern before coating. Clean the cup, nozzle and needle immediately after use.
| Item type | Gravity feed spray gun |
|---|---|
| Nozzle | 1.5 mm |
| Cup | 0.5 l plastic flow cup |
| Main use | Primer, filler and general coating application |
| Article number | 583010001 |
|---|---|
| EAN / GTIN | 4016176189803 |
No. Always match nozzle size and viscosity to the material data.
Dried coating residue can disturb the spray pattern and damage the finish on later jobs.
© 2026 All Rights Reserved.
Start with the job, the surface or the step you are working on.
