Description
Mipa 2K-HS-Grundfiller F 54 is a fast sandable 2K primer surfacer with high filling power, anticorrosion protection and good adhesion properties. Mipa 2K-HS-Grundierfüller F54 is suitable for painting small areas up to complete painting.
Product information
In addition, spot repair work / partial varnishing can be carried out reliably and without sagging or the formation of edges. Spreading rate: 5,0 – 6,0 m²/l
What is this product used for?
Use this filler for repairing uneven areas, shaping contours and preparing the substrate before primer and topcoat. It is intended for repair work where flexibility, adhesion and sanding properties matter.
Use and processing
Mix the filler with the supplied hardener in the stated ratio (4:1). Apply in thin layers on a clean, sanded substrate, allow it to cure and then sand to the required contour.
Key features
- Filler
- Finish / colour: white
- Size / content: 1 l, 4 l
- Corrosion protection
Technical data
| Product type | Filler |
| Size / content | 1 l, 4 l |
| Finish / colour | white |
| Mixing ratio | 4:1 |
| Thinner | Mipa 2K-Thinner Normal V 25, Mipa 2K-Thinner Short V 10 |
| Pot life | 1 h with Mipa 2K-Härter H 5 at 20 °C 2 h with Mipa 2K-Härter H 10 at 20 °C 2 h with Mipa 2K-MS-Härter MS 10 at 20 °C |
| Drying / flash-off | 5 – 8 min between the coats 10 – 15 min before oven drying |
| Often used together with |
|
For this system, the compatible hardener and thinner options are listed in the technical information table.
