Description
Mipa P 85 is a bright white, particularly easy to sand two-component putty based on polyester resin that provides adhesion on iron, steel, GRP and wood.
Product information
Its fine particle size and its excellent hiding power make Mipa P 85 perfectly suitable to be used as covering and fine putty applied in thin and very thin layers, as finishing coat over polyester body fillers, to close any pin holes and little surface imperfections and to eliminate little defects in paintwork, scratches and so on. An application on vertical surfaces is possible without any problems.
Typical applications
Use this filler for repairing uneven areas, shaping contours and preparing the substrate before primer and topcoat. It is intended for repair work where flexibility, adhesion and sanding properties matter.
Use and processing
Mix the filler with the supplied hardener in the stated ratio (100:2). Apply in thin layers on a clean, sanded substrate, allow it to cure and then sand to the required contour. From +10 °C and up to 80 % relative air humidity. Ensure an adequate supply and exhaust air ventilation
Features
- Body filler
- Finish / colour: bright white
- Size / content: 250 g, 1 kg, 2 kg
- Suitable for: steel, GRP, and wood
- Excellent hiding power
Technical information
| Product type | Body filler |
| Size / content | 250 g, 1 kg, 2 kg |
| Finish / colour | bright white |
| Suitable for | steel, GRP, and wood |
| Mixing ratio | 100:2 |
| Pot life | 4 – 5 min with Mipa Härter P at 20 °C Spray / processing viscosity: |
| Processing conditions | From +10 °C and up to 80 % relative air humidity. Ensure an adequate supply and exhaust air ventilation |
| VOC | EU limit value for this product (category B / b): 250 g / l. This product contains max. 25 g / l of VOC |
| Often used together with |
|
Suitable preparation or cleaning products that are explicitly mentioned in the product data are linked there as well.
