Description
Mipa Kontroll-Spray schwarz is a black guide coat that is used to make irregularities visible when sanding putty and filler surfaces. It reveals any imperfections in the surface, as it blackens the remaining slow spots during flatting that have been caused by irregularities or pitting.
Product details
Once the entire guide coat has been removed, you can be assured that the remaining filler or putty surface is smooth, absolutely flat and free from imperfections. Black guide coat used to make irregularities visible once the putty and filler has been applied and prepared for the following sanding.
Where does this product work best?
Use this filler for repairing uneven areas, shaping contours and preparing the substrate before primer and topcoat. It is intended for repair work where flexibility, adhesion and sanding properties matter.
Application notes
Mix the filler with the supplied hardener until the colour is uniform. Apply in thin layers on a clean, sanded substrate, allow it to cure and then sand to the required contour.
Features
- Protective spray
- Finish / colour: matt black
- Size / content: 400 ml
- Pack information: 6 x 400 ml
- GTIN: 4016176032536
Technical information
| Product type | Protective spray |
| Size / content | 400 ml |
| Finish / colour | matt black |
| Pack information | 6 x 400 ml |
| Drying / flash-off | at 20 °C Sandable after approx. 5 – 10 min Processing conditions From +10 °C and up to 80 % relative humidity. Ensure adequate air ventilation |
| GTIN | 4016176032536 |
| Often used together with |
|
Suitable preparation or cleaning products that are explicitly mentioned in the product data are linked there as well.
