Description
Mipa 2K-EP-Expressprimer EPX is a fast drying, chromate-free wet-on-wet filler based on epoxy resins and designed for application in vehicles construction and car refinish. Very good flow, very fast drying and the outstanding overspray absorption ensure fast overcoatability after only 20 -30 minutes and optimum gloss at the same time.
About this product
If necessary, Mipa 2K-EP-Expressprimer EPX can be sanded after only 3 – 4 hours drying at 20 °C. The drying periods to become overcoatable and sandable depend on the applied dry film thickness: In case of one spray pass of approx.
Typical applications
Use this filler for repairing uneven areas, shaping contours and preparing the substrate before primer and topcoat. It is intended for repair work where flexibility, adhesion and sanding properties matter.
Use and processing
Mix the filler with the supplied hardener in the stated ratio (1:1). Apply in thin layers on a clean, sanded substrate, allow it to cure and then sand to the required contour. from +10 °C and up to 80 % relative humidity. Ensure adequate ventilation
Key features
- Primer
- Size / content: 1 l
- Pack information: 6 x 1 l
- Suitable for: cars, zinced substrates, steel, and aluminium
- Fast drying
- Gloss finish
Technical data
| Product type | Primer |
| Size / content | 1 l |
| Pack information | 6 x 1 l |
| Suitable for | cars, zinced substrates, steel, and aluminium |
| Mixing ratio | 1:1 |
| Hardener | EPH |
| Pot life | approx. 4 h at 20 °C Spray / processing viscosity: ready for use after having added the hardener |
| Processing conditions | from +10 °C and up to 80 % relative humidity. Ensure adequate ventilation |
| Storage | at least 2 years in unopened original containers VOC Regulation : EU limit value for this product (category B / c): 540 g / l This product contains max |
| GTIN | 4016176538854 |
