Description
Mipa P 60 S PE-Spritzfiller styrolreduziert is a two-component body filler based on polyester resin and with a low styrene content for steel substrates, GRP, wood or sanded, solid paintwork.
Product details
This product is especially suitable for filling irregularities, deep sanding traces as well as rough pre-repair work in a single filling process. The proportion of styrene of Mipa P 60 styrolreduziert is less than 10 %.
Typical applications
Use this filler for repairing uneven areas, shaping contours and preparing the substrate before primer and topcoat. It is intended for repair work where flexibility, adhesion and sanding properties matter.
How to use
Mix the filler with the supplied hardener in the stated ratio (30:1 by weight; 100:5 by volume). Apply in thin layers on a clean, sanded substrate, allow it to cure and then sand to the required contour. From +10 °C and up to 80 % relative air humidity. Ensure an adequate supply and exhaust air ventilation
Key features
- Body filler
- Finish / colour: grey
- Size / content: 1 l
- Pack information: 6 x 1 l
- Suitable for: steel, GRP, and wood
- GTIN: 4016176001198
Technical details
| Product type | Body filler |
| Size / content | 1 l |
| Finish / colour | grey |
| Pack information | 6 x 1 l |
| Suitable for | steel, GRP, and wood |
| Mixing ratio | 30:1 by weight; 100:5 by volume |
| Thinner | Mipa PE-Thinner |
| Processing conditions | From +10 °C and up to 80 % relative air humidity. Ensure an adequate supply and exhaust air ventilation |
| Storage | At least 1 years in unopened original container |
| VOC | EU limit value for this product (category B / b): 250 g / l. This product contains max. 250 g / l of VOC |
| GTIN | 4016176001198 |
