Description
Mipa 1K-UV-Spachtel is a high-quality, UV drying fine putty for fast and efficient filling of small damages. It can be sanded after only 5 minutes of irradiation with a UV LED lamp or Hg lamp (mercury vapour lamp).
About this product
Thus, significant savings can be made by eliminating heating-related costs. In the same time, cycles times are reduced since the painting process is not interrupted by heating intervals.
What is this product used for?
Use this filler for repairing uneven areas, shaping contours and preparing the substrate before primer and topcoat. It is intended for repair work where flexibility, adhesion and sanding properties matter.
Application notes
Mix the filler with the supplied hardener until the colour is uniform. Apply in thin layers on a clean, sanded substrate, allow it to cure and then sand to the required contour. From +15 °C and up to 80 % relative air humidity. Ensure an adequate air ventilation
Features
- Filler
- Size / content: 500 g
- Pack information: 6 x 500 g
- Suitable for: galvanised substrates, steel, aluminium, and plastic
- Fast drying
- UV resistance
Technical information
| Product type | Filler |
| Size / content | 500 g |
| Pack information | 6 x 500 g |
| Suitable for | galvanised substrates, steel, aluminium, and plastic |
| Pot life | related hardening. Spray / processing viscosity: |
| Processing conditions | From +15 °C and up to 80 % relative air humidity. Ensure an adequate air ventilation |
| Storage | At least 2 years at room temperature (20°C) in unopened original container. Immediately close the container light-proof after each use |
| VOC | EU limit value for this product (category B / b): 250 g / l. This product contains max. 3 g / l of VOC |
| GTIN | 4016176661521 |
