Description
Mipa P 70 is a high-quality, non-asbestos, aluminium-pigmented 2K body filler based on polyester resin that has been especially designed to meet the high quality requirements of automotive industry and refinish sector in terms of processing, adhesion and sandability.
Product details
This product is suitable to even dents and irregularities on iron and steel or even GRP and wood. An application on vertical surfaces is possible without any problems.
What is this product used for?
Use this filler for repairing uneven areas, shaping contours and preparing the substrate before primer and topcoat. It is intended for repair work where flexibility, adhesion and sanding properties matter.
How to use
Mix the filler with the supplied hardener in the stated ratio (100:2). Apply in thin layers on a clean, sanded substrate, allow it to cure and then sand to the required contour. From +10 °C and up to 80 % relative air humidity. Ensure an adequate supply and exhaust air ventilation
Key features
- Body filler
- Finish / colour: red
- Size / content: 1 kg
- Pack information: 12 x 1 kg
- Suitable for: steel, aluminium, GRP, and wood
- GTIN: 4016176618396
Technical information
| Product type | Body filler |
| Size / content | 1 kg |
| Finish / colour | red |
| Pack information | 12 x 1 kg |
| Suitable for | steel, aluminium, GRP, and wood |
| Mixing ratio | 100:2 |
| Pot life | 4 – 5 min with Mipa Härter P at 20 °C Spray / processing viscosity: |
| Processing conditions | From +10 °C and up to 80 % relative air humidity. Ensure an adequate supply and exhaust air ventilation |
| VOC | EU limit value for this product (category B / b): 250 g / l. This product contains max. 25 g / l of VOC |
| GTIN | 4016176618396 |
| Often used together with |
|
Suitable preparation or cleaning products that are explicitly mentioned in the product data are linked there as well.
