MP Fine sanding pad gives the tread or walkway edge a cleaner mechanical key before coating. Use it to scuff sound paint, dull glossy areas and prepare edges where a coating can otherwise lift first.
Coatblend guided shopping
Stair treads and walkway edges need a coating that remains visible, durable and grippy under repeated foot traffic needs a coating build that gives grip, wear resistance and controlled surface preparation before the first coat goes on. This guide focuses on the specified Mipa and MP products for creating a durable anti slip finish on stair treads and walkway edges.
MP Fine sanding pad gives the tread or walkway edge a cleaner mechanical key before coating. Use it to scuff sound paint, dull glossy areas and prepare edges where a coating can otherwise lift first.
Mipa PU 350-50 is the main semi gloss 2K PU anti slip coating for walkable machine parts, steps, floors and constructions. It is suited to brush or roller work when a durable grip surface is needed.
Mipa Protector black creates a tough textured protective finish, while Mipa Grip Additive increases slip resistance for foot traffic areas. This method suits black textured utility surfaces where extra grip matters.
Mipa PUR Plus Hardener A60, Mipa 2K Hardener H10 short and Mipa 2K Thinner Normal V25 support compatible Mipa 2K coating work. Use the component named by the technical sheet for the chosen coating and application method.
Remove loose paint, rust, dirt, oil and standing moisture from the tread or walkway edge. Any weak edge or flaking layer should be corrected before a grip coating is applied.
Scuff the tread or walkway edge with the MP sanding pad, paying extra attention to front edges, corners and glossy patches. A dull and stable surface helps the coating bond more consistently.
Use Mipa PU 350-50 when the job calls for a 2K PU anti slip topcoat. Use Mipa Protector black with Mipa Grip Additive when a black textured protective finish is the better match.
Measure hardener and thinner according to the matching product information, then mix carefully before application. Do not exchange hardeners between systems unless the technical data allows it.
Apply an even coat over the traffic area and keep edges well covered. Let the coating cure fully before putting the tread or walkway edge back into use, then inspect high wear edges regularly.
Choose Mipa PU 350-50 when a semi gloss 2K anti slip paint in the required colour group is the main finish.
Choose Mipa Protector black with Mipa Grip Additive where a tougher black utility surface and stronger texture are preferred.
Mipa Protector 2K Spray can help on limited black textured areas, especially where aerosol application is more practical than mixing a larger pack.
Treads and walkway edges are small areas with high wear. Keep the build controlled, avoid glossy unkeyed patches and inspect edges after the first period of use.
© 2026 All Rights Reserved.