Paint motorcycle brackets, stands and small metal parts

Motorcycle brackets, stands and small metal parts

Guide to painting motorcycle brackets, stands and small metal parts

Motorcycle brackets, stands and small metal parts need the same coating discipline as larger frame parts, but edge coverage and handling control matter even more. Clean metal, keyed old coating, epoxy primer and a 2K colour finish help small structure parts look finished and stay protected.

What do you need to paint motorcycle brackets and small metal parts?

Cleaning and degreasing

Mipa silicone remover removes oil, chain grease and handling marks before sanding or primer.

Small part sanding

MP Hand Support Plate or suitable sanding pads help key brackets, stands, tabs and flat faces before primer.

Epoxy primer filler

Mipa EP primer filler with E 10 hardener and EP thinner gives prepared metal a protective primer foundation.

2K epoxy primer spray

Mipa 2K-EP Primer Filler Spray gives a practical aerosol epoxy primer option for individual small parts.

2K colour topcoat

Mipa PUR HS Ready Mixed colour gives the finished 2K colour layer for primed motorcycle metal parts.

Topcoat companions

Mipa 2K-HS Hardener HS 10 short and Mipa 2K Thinner Normal V 25 support compatible 2K colour application.

How to paint motorcycle brackets, stands and small metal parts

1
Remove and clean

Remove the part where practical, clean away grease and inspect edges, holes and contact faces.
2
Sand the paint area

Key stable old coating and prepared metal with attention to bends, welds and thin edges.
3
Prime the part

Use liquid EP primer filler or 2K EP primer filler spray according to the part size and application method.
4
Apply 2K colour

Apply Mipa PUR HS Ready Mixed colour in light coats so edges do not overload with paint.
5
Cure before refitting

Let the coating cure before washers, bolts, springs or stands press against the fresh finish.

Which primer format fits small motorcycle parts?

Aerosol primer for individual parts

Use 2K EP Primer Filler Spray for a few brackets, stands or small fittings where spray gun setup would be excessive.

Liquid EP primer for multiple parts

Use the liquid EP primer filler system when several parts are sprayed together or more film build control is needed.

PUR HS for the final colour

Use PUR HS Ready Mixed as the 2K colour finish after the primer has been prepared for coating.

Technical details

Mipa EP primer filler combines filling and adhesion promoter properties with high corrosion protection on prepared metal.
Mipa 2K EP Primer Filler Spray gives an aerosol epoxy primer filler format for smaller repair and coating work.
Small parts need careful edge coverage because thin edges, holes and bends are common points for coating failure.
Mask threads, bushings, bearing contact points and sliding faces before primer and topcoat.

Practical suggestion

Hang small parts so all sides can be reached without touching fresh coating. Mark threads, bushings and contact surfaces before spraying so the finished part can be refitted without scraping paint from functional areas.