Description
Mipa P 35 Elastic is a flexible body filler and putty which is perfectly suitable for overcoatable plastic parts and which enables the shaping of contours. Very good adhesion on steel, aluminium, GRP and wood, high flexibility, short drying time and easy to sand.
Product information
Special PE-putty incl. hardener for repairs on plastic parts.
Typical applications
Use this filler for repairing uneven areas, shaping contours and preparing the substrate before primer and topcoat. It is intended for repair work where flexibility, adhesion and sanding properties matter.
Application notes
Mix the filler with the supplied hardener in the stated ratio (100:2). Apply in thin layers on a clean, sanded substrate, allow it to cure and then sand to the required contour. From +10 °C and up to 80 % relative air humidity. Ensure an adequate air ventilation
Key features
- Body filler
- Finish / colour: graphite grey
- Size / content: 1 kg
- Pack information: 12 x 1 kg
- Suitable for: steel, aluminium, GRP, and wood
- Flexible film
Technical information
| Product type | Body filler |
| Size / content | 1 kg |
| Finish / colour | graphite grey |
| Pack information | 12 x 1 kg |
| Suitable for | steel, aluminium, GRP, and wood |
| Mixing ratio | 100:2 |
| Pot life | 4 – 5 min with Mipa Härter P at 20 °C Spray / processing viscosity: |
| Processing conditions | From +10 °C and up to 80 % relative air humidity. Ensure an adequate air ventilation |
| VOC | EU limit value for this product (category B / b): 250 g / l. This product contains max. 25 g / l of VOC |
| GTIN | 4016176187564 |
| Often used together with |
|
Suitable preparation or cleaning products that are explicitly mentioned in the product data are linked there as well.
