Description
Mipa P 88 light green 850 ml incl. hardener is a body filler for repairs and contour work on prepared substrates. It combines easy shaping and sanding with the adhesion needed before the next coating steps.
Product details
Pourable, self-levelling 2-component polyester finishing putty to be applied in thin and very thin layers as finishing coat over polyester body fillers, to close any pin holes and small paint defects (scratches, sanding marks, and so on). The achieved surface is very smooth and similar o varnish with increased gloss and requires only a little sanding work.
Where does this product work best?
Use this filler for repairing uneven areas, shaping contours and preparing the substrate before primer and topcoat. It is intended for repair work where flexibility, adhesion and sanding properties matter.
Use and processing
Mix the filler with the supplied hardener in the stated ratio (100:2). Apply in thin layers on a clean, sanded substrate, allow it to cure and then sand to the required contour. From +10 °C and up to 80 % relative air humidity. Ensure an adequate air ventilation
Features
- Body filler
- Finish / colour: light green
- Size / content: 850 ml
- Pack information: 6 x 850 ml
- Suitable for: zinced substrates, steel, aluminium, and GRP
- Excellent hiding power
Technical details
| Product type | Body filler |
| Size / content | 850 ml |
| Finish / colour | light green |
| Pack information | 6 x 850 ml |
| Suitable for | zinced substrates, steel, aluminium, and GRP |
| Mixing ratio | 100:2 |
| Pot life | 3 min with Mipa Härter P at 20 °C Spray / processing viscosity: |
| Processing conditions | From +10 °C and up to 80 % relative air humidity. Ensure an adequate air ventilation |
| VOC | EU limit value for this product (category B / b): 250 g / l. This product contains max. 25 g / l of VOC |
| GTIN | 4016176650822 |
