MP Protective Film 50 cm x 100 m is a blue transparent LDPE protection film with full surface adhesive for clean surface protection. The film protects glass, prepared surfaces and work areas against mechanical load, dirt and overspray related contamination during masking, preparation and finishing work.
The 0.04 mm film thickness gives a stable protective layer while keeping the material easy to apply over flat surfaces. A water based acrylate adhesive gives controlled adhesion, while the blue transparent film remains visible during use. The film is intended for dry and clean surfaces, especially glass surfaces in indoor and outdoor work.
The 50 cm width suits the roll to windows, panels, doors, trim zones and surface strips where large masking film is too wide. A 100 m roll supports repeated work without frequent roll changes. UV resistant adhesive mass allows longer protection periods during staged repair, renovation or coating work.
MP Protective Film maintains cleaner work areas by shielding surfaces before sanding dust, handling marks or coating overspray reach them. The film belongs in preparation and masking consumables where reliable surface protection is needed before the next operation begins. Clean application, secure contact and controlled removal are central to its role.
The blue film format is appropriate on areas where the edge of the protected zone must remain easy to see during preparation. The roll can be cut to the required length and applied over glass, panels, trim zones or temporary protection areas. A smooth laydown reduces loose edges, while the adhesive-backed film stays suited to controlled short-term protection work.
| Technical point | Value |
|---|---|
| Material role | Self adhesive LDPE protection film |
| Colour | Blue transparent |
| Dimensions | 50 cm x 100 m |
| Film thickness | 0.04 mm plus or minus 10 percent |
| Adhesive | Water based acrylate |
| UV resistance | Up to 30 days |
| Article number | 516601050 |
|---|---|
| EAN / GTIN | 4016176327229 |
© 2026 All Rights Reserved.
Start with the job, the surface or the step you are working on.
