Description
Mipa EP-Primer-Surfacer is a chromate-free wet-in-wet filler based on epoxy resin designed to coat commercial vehicles and to refinish cars. Very good flow, very fast drying and the outstanding overspray absorption ensure fast overcoatability after only 30-45 minutes and optimum gloss retention at the same time.
Product information
Perfectly suitable as primer for polyester body fillers and polyester spraying filler. Adhesion to steel, aluminium and zinced substrates.
Typical applications
Use this filler for repairing uneven areas, shaping contours and preparing the substrate before primer and topcoat. It is intended for repair work where flexibility, adhesion and sanding properties matter.
Use and processing
Mix the filler with the supplied hardener in the stated ratio (2:1). Apply in thin layers on a clean, sanded substrate, allow it to cure and then sand to the required contour.
Features
- Primer
- Finish / colour: light grey
- Size / content: 1 l, 5 l
- Suitable for: commercial vehicles, cars, zinced substrates, and steel
- Fast drying
Technical information
| Product type | Primer |
| Size / content | 1 l, 5 l |
| Finish / colour | light grey |
| Suitable for | commercial vehicles, cars, zinced substrates, and steel |
| Mixing ratio | 2:1 |
| Thinner | Mipa 2K-Thinner |
| Pot life | 5 h with Mipa Härter E 5 at 20 °C |
| Drying / flash-off | 5 – 8 min between coats 10 – 15 min before oven drying |
| Often used together with |
|
For the compatible thinner options for this product, see the linked products in the technical information table.
