Description
Please observe the detailed pre-treatment instructions for this purpose in the section Processing Instructions / Plastic Substrates on page 3. Furthermore, it is possible to overcoat intact, sound e-coatings without any pre-sanding.
Product details
Mipa 2K-HS-NIN-Füller can be overcoated without intermediate sanding within 5 days. Mipa 2K-HS-Nass-in-Nass-Füller F 37 can be overcoated after a drying time of only 15 minutes at 20°C without loss of gloss and ensures outstanding overspray absorption at the same time.
What is this product used for?
Use this filler for repairing uneven areas, shaping contours and preparing the substrate before primer and topcoat. It is intended for repair work where flexibility, adhesion and sanding properties matter.
Use and processing
Mix the filler with the supplied hardener in the stated ratio (5:1). Apply in thin layers on a clean, sanded substrate, allow it to cure and then sand to the required contour.
Key features
- Filler
- Finish / colour: light grey (approx. RAL 7047)
- Size / content: 1 l, 3 l
- Suitable for: cars, galvanised substrates, steel, and aluminium
- Gloss finish
Technical data
| Product type | Filler |
| Size / content | 1 l, 3 l |
| Finish / colour | light grey (approx. RAL 7047) |
| Suitable for | cars, galvanised substrates, steel, and aluminium |
| Mixing ratio | 5:1 |
| Thinner | Mipa 2K-Thinner Normal V 25 |
| Pot life | 2 h at 20 °C |
| Often used together with |
|
For this system, the compatible hardener and thinner options are listed in the technical information table.
