Description
Mipa 2K-HS-Filler EF 42 is a high-fill and very easy to sand filler for car refinishing using renewable raw materials.
Product details
Mipa 2K-HS-Filler EF 42 is suitable for the painting of small areas up to the complete coating, even the filler of partial areas (spot repair) is possible without sagging and edge formation. The proportion of renewable raw materials in the ready-to-spray mixture is 25 % when used with Mipa 2K-MS-Härter EMS 25 or Mipa 2K-HS-Härter EHS 25.
Typical applications
Use this filler for repairing uneven areas, shaping contours and preparing the substrate before primer and topcoat. It is intended for repair work where flexibility, adhesion and sanding properties matter.
How to use
Mix the filler with the supplied hardener in the stated ratio (4:1). Apply in thin layers on a clean, sanded substrate, allow it to cure and then sand to the required contour. From +10 °C and up to 80 % relative humidity. Ensure sufficient supply and exhaust air
Key features
- Filler
- Finish / colour: light grey
- Size / content: 1 l
- Pack information: 6 x 1 l
- Suitable for: cars
- Easy sanding
Technical data
| Product type | Filler |
| Size / content | 1 l |
| Finish / colour | light grey |
| Pack information | 6 x 1 l |
| Suitable for | cars |
| Mixing ratio | 4:1 |
| Hardener | EMS 25 |
| Thinner | Mipa 2K-Thinner |
| Pot life | 50 – 60 min with Mipa 2K-MS-Härter EMS 25 50 – 60 min with Mipa 2K-HS-Härter EHS 25 Spray / processing viscosity: |
| Processing conditions | From +10 °C and up to 80 % relative humidity. Ensure sufficient supply and exhaust air |
| GTIN | 4016176702323 |
| Often used together with |
|
For the compatible thinner options for this product, see the linked products in the technical information table.
