Description
Mipa P 80 is a high-quality two-component body filler based on polyester resin with lamellar pigmentation. It adheres on iron, steel, aluminium, zinc, GRP and wood.
About this product
Mipa P 80 Kaltmetall is easy to apply and, after a short drying time, it can be well sanded without producing a lot of dust. It is characterized by its excellent adhesion and bending resistance.
What is this product used for?
Use this filler for repairing uneven areas, shaping contours and preparing the substrate before primer and topcoat. It is intended for repair work where flexibility, adhesion and sanding properties matter.
Application notes
Mix the filler with the supplied hardener in the stated ratio (100:2). Apply in thin layers on a clean, sanded substrate, allow it to cure and then sand to the required contour.
Key features
- Body filler
- Size / content: 1 kg
- Pack information: 12 x 1 kg
- Suitable for: steel, aluminium, GRP, and wood
- GTIN: 4016176037104
Technical information
| Product type | Body filler |
| Size / content | 1 kg |
| Pack information | 12 x 1 kg |
| Suitable for | steel, aluminium, GRP, and wood |
| Mixing ratio | 100:2 |
| Pot life | 4 – 6 min with Mipa Härter P at 20 °C Spray / processing viscosity: |
| Drying / flash-off | , it can be well sanded without producing a lot of dust. It is characterized by its excellent adhesion and bending resistance |
| GTIN | 4016176037104 |
| Often used together with |
|
Suitable preparation or cleaning products that are explicitly mentioned in the product data are linked there as well.
