Description
High-build 2K zinc phosphate epoxy primer for steel, zinced substrates, aluminium, GRP and mineral substrates.
Product information
Suitable as priming coat even for both underwater and chemical protective coatings and as intermediate coating for EP zinc dust primers. Especially suitable for airmix/ airless application.
Where does this product work best?
This product is intended for professional coating work on zinced substrates, zinced steel, steel, and aluminium with a RAL 7032 finish.
Application notes
Prepare the substrate thoroughly and remove grease, dust and loose contamination before coating. Mix the product in the stated ratio (1:1) with Mipa EP 964-10; adjust with Mipa Thinner EP if required. Apply even coats and respect the flash-off, drying and recoating times of the full system. From + 10 °C and up to 80 % relative humidity. Ensure adequate air ventilation
Features
- Primer
- Finish / colour: RAL 7032
- Size / content: 14 kg
- Suitable for: zinced substrates, zinced steel, steel, and aluminium
- High-build formulation
- Mixing ratio: 1:1
Technical information
| Product type | Primer |
| Size / content | 14 kg |
| Finish / colour | RAL 7032 |
| Suitable for | zinced substrates, zinced steel, steel, and aluminium |
| Mixing ratio | 1:1 |
| Hardener | Mipa EP 964-10 |
| Thinner | Mipa Thinner EP |
| Pot life | with hardener -10 approx. 5 h at 20 °C Spray / processing viscosity: |
| Processing conditions | From + 10 °C and up to 80 % relative humidity. Ensure adequate air ventilation |
| Storage | For at least 3 years in the unopened original container. Optimum storage conditions between + 5 °C and + 25 °C, avoid direct sunlight |
| GTIN | 4016176407198 |
| Often used together with |
|
For this system, the compatible hardener and thinner options are listed in the technical information table.
