MP Sanding Sponge helps prepare corners, wall edges and local repairs before the floor coating stage. Use it to dull sound areas and smooth small corrections after the surface is clean.
Coatblend guided shopping
A pool equipment room floor needs a coating that can handle foot traffic, cleaning, damp use conditions and contact with routine service dirt. The specified Mipa WEP floor system gives a waterborne 2K epoxy method for suitable interior mineral floors.
MP Sanding Sponge helps prepare corners, wall edges and local repairs before the floor coating stage. Use it to dull sound areas and smooth small corrections after the surface is clean.
Mipa WEP 2300-50 is the semi gloss waterborne 2K epoxy floor coating for mineral and metallic substrates in interior use. It is suited to working floors where mechanical and chemical resistance matter.
Mipa WEP 9300-25 is the matching hardener component for the WEP 2300-50 floor system. Correct mixing is essential because the hardener turns the coating into a cured 2K epoxy film.
Use this water based thinner to adjust the WBS finish when the application method requires it.
Check that the floor is stable, clean, dry enough for the coating system and free from loose old coating. Oil, detergent residue and standing moisture should be removed before sanding.
Sand or mechanically key smooth areas and clean away dust. Edges, drain zones and door thresholds need special attention because water and traffic collect there.
Combine Mipa WEP 2300-50 with Mipa WEP 9300-25 hardener using the ratio in the technical information. Adjust only with the specified WBS deionised water method where needed.
Work across the floor in controlled sections, keeping film build consistent. Avoid coating over puddles, dust or cleaning residue.
Keep the floor away from traffic, water and equipment movement until the coating has cured sufficiently for service.
Use Mipa WEP 2300-50 where a semi gloss waterborne 2K epoxy coating is the required floor finish.
Use Mipa WEP 9300-25 with the floorcoat, because the hardener is part of the coating system rather than an optional add on.
Use Mipa WBS deionised water only where the WEP technical information calls for adjustment, not as a general cleaning water or improvised thinner.
Pool equipment rooms often have wet footprints and service traffic. Prepare drains, thresholds and equipment feet carefully so the coating does not fail first at the hardest working edges.
© 2026 All Rights Reserved.