Mipa WBS Cleaner prepares the surface inside the waterborne system, removing contamination that can disturb flow, adhesion or the final look.
Guided shopping manual
Damaged wooden furniture needs more than a quick colour coat. Loose coating, dents, chipped edges and contaminated hand contact areas must be corrected before the satin matt waterborne finish is applied.
Mipa WBS Cleaner prepares the surface inside the waterborne system, removing contamination that can disturb flow, adhesion or the final look.
Mipa WBS deionised water is the dedicated thinner for the WBS finish, used only when the coating needs controlled adjustment for brushing, rolling or spraying.
Mipa WPA 2100-40 gives a waterborne 1K PU acrylic satin matt finish for common wood surfaces, with a calm low-sheen look for furniture and visible interior pieces.
Check whether the wood is solid, whether old coating is flaking and whether dents or chips must be corrected before painting.
Use Mipa WBS Cleaner on old furniture so polish, skin oils and dirt are not sanded into the surface.
Feather damaged edges and sand repaired areas until the profile feels continuous under the hand.
Use Mipa WPA 2100-40 in controlled thin coats, keeping a wet edge across flat faces and avoiding buildup on corners.
Keep the furniture away from handling, stacking and cleaning until the new surface has hardened enough for normal use.
Mipa WPA 2100-40 gives repaired furniture a softer even look that helps old and newly sanded areas read as one surface.
Cleaning before sanding is important on damaged furniture because old polish and grease can sit in scratches, dents and carved details.
Mipa WBS deionised water keeps viscosity adjustment inside the waterborne system when the finish needs better flow for the application method.
Run a bare hand lightly over repaired edges after sanding. If you can still feel a ridge, it will usually remain visible after the satin matt finish.
© 2026 All Rights Reserved.