Mipa 1K UV Filler Spray is made for fast spot repairs where drying speed has a direct impact on the job. After UV curing, the filler reaches a hard, sandable surface in only a short time, which helps the repair move forward without a longer oven or air-dry interval.
Because Mipa 1K UV filler spray 400 ml cures by UV light rather than conventional heat, the substrate does not need to be warmed up in the same way. That is especially helpful on smaller repair areas and on parts where unnecessary heat is best avoided. The cured surface sands cleanly and gives a firm base for the following coating steps.
The filler is suited to local repairs on steel, iron, aluminium and galvanised substrates, and it also works well on properly prepared plastics in combination with the correct adhesion primer. It is aimed at compact repairs where speed, control and a clean filler surface matter more than large-area filling.
In a 400 ml aerosol, Mipa 1K UV filler spray 400 ml keeps UV filler work practical for spot preparation, local refinishing and small sections that need a rapid sanding-ready surface before moving into primer or topcoat stages.
| Product type | UV-curing filler spray |
|---|---|
| Colour | Grey |
| Content | 400 ml |
| Typical use | Spot repair and local refinishing |
| Drying | Approx. 5 min by UV LED or mercury vapour lamp |
| Key properties | Fast cycle, hard surface, excellent sandability |
| Article number | 213770000 |
|---|---|
| EAN / GTIN | 4016176622577 |
© 2026 All Rights Reserved.
Start with the job, the surface or the step you are working on.
